Yealink W53P

Administrator’s Guide for W60P/W53P/W41P DECT Phones
20
Web UI Network->Basic->IPv6 Config->Static IP Address->Default Gateway
Handset UI
OK->Settings->System Settings->Network (default PIN: 0000) ->Basic->IPv6->IP Address Type: Static-
>Default Gateway
DD Phone
UI
Menu->Settings->Advanced Settings (default password: 0000)->Network->WAN Port->IPv6->Static IPv6
Client->Default Gateway
Parameter
static.network.ipv6_static_dns_enable
[1]
<y0000000000xx>.cfg
Description
It triggers the static IPv6 DNS feature to on or off.
Note: It works only if “static.network.ipv6_internet_port.type” is set to 0 (DHCP).
Permitted
Values
0-Off, the IP phone will use the IPv6 DNS obtained from DHCP.
1-On, the IP phone will use manually configured static IPv6 DNS.
Default 0
Web UI Network->Basic->IPv6 Config->IPv6 Static DNS
Handset UI
OK->Settings->System Settings->Network (default PIN: 0000) ->Basic->IPv6->IP Address Type: DHCP-
>DNS Type: Manual
DD Phone
UI
Menu->Settings->Advanced Settings (default password: 0000) ->Network->WAN Port->IPv6->DHCP
IPv6 Client->Static DNS
Parameter
static.network.ipv6_primary_dns
[1]
<y0000000000xx>.cfg
Description
It configures the primary IPv6 DNS server.
Example:
static.network.ipv6_primary_dns = 3036:1:1:c3c7:c11c:5447:23a6:256
Note: It works only if “static.network.ip_address_mode" is set to 1 (IPv6) or 2 (IPv4 & IPv6). In DHCP envir-
onment, you also need to make sure “static.network.ipv6_static_dns_enable" is set to 1 (On).
Permitted
Values
IPv6 Address
Default Blank
Web UI Network->Basic->IPv6 Config->Static IP Address->Primary DNS
Handset UI
OK->Settings->System Settings->Network (default PIN: 0000) ->Basic->IPv6->IP Address Type: Static-
>Primary DNS
DD Phone
UI
Menu->Settings->Advanced Settings (default password: 0000)->Network->WAN Port->IPv6->Static IPv6
Client->Pri.DNS
Or Menu->Settings->Advanced Settings (default password: admin)->Network->WAN Port->IPv6-
>DHCP IPv6 Client->Static DNS(Enabled) ->Pri.DNS
Parameter
static.network.ipv6_secondary_dns
[1]
<y0000000000xx>.cfg
Description
It configures the secondary IPv6 DNS server.
Example:
static.network.ipv6_secondary_dns = 2026:1234:1:1:c3c7:c11c:5447:23a6
Note: It works only if “static.network.ip_address_mode" is set to 1 (IPv6) or 2 (IPv4 & IPv6). In DHCP envir-
onment, you also need to make sure “static.network.ipv6_static_dns_enable" is set to 1 (On).
Permitted
Values
IPv6 Address