Chapter 3 PERFORMING MEASUREMENTS
3-22
Changing the Average Condition
Average condition means the method of averaging the data obtained by measurement.
The following two average methods are available.
• Averaging by times
• Averaging by intervals
The average condition can be changed as explained below.
♦ Example: “INTERVAL” → “TIMES 2^*”
For details on average measurement, refer to page 3-56.
1. Locate the cursor to “AVE CONDITION” by using the rotary knob or the arrow
key.
2. Press [ENTER].
A selection window will appear.
*: Indicates the default setting.
3. Locate the cursor to “TIMES 2^*” by using the rotary knob or [S] / [T].
4. Press [ENTER] to register the change made to the average condition setting.
TIP
TIMES 2^*
TIMES *k
Selectable
average conditions
*INTERVAL
Refer
To Next Page
Loading...
