Chapter 2 CHANGING SYSTEM SETTINGS
2-6
Changing the Trace Type
The trace type can be changed as explained below.
♦ Example: “LINE” → “DOT”
1. Locate the cursor to “TRACE TYPE” by using the rotary knob or the arrow key.
2.
Press [ENTER].
A selection window will appear.
3. Locate the cursor to “DOT” by using the rotary knob or [S] / [T].
4. Press [ENTER] to register the change made to the trace type.
The change will not be registered if [ESC] is pressed instead of [ENTER].
*LINE Displays the trace in line form.
Selectable
trace types
DOT Displays the trace in dot form.
*: Indicates the default setting.
TIP
Caution
To Next Page
Loading...
