Chapter 2 CHANGING SYSTEM SETTINGS
2-10
Changing the Grid Setting
The grid setting can be changed as explained below.
♦ Example: “DISPLAY” → “NonDISPLAY”
1. Locate the cursor to “GRID” by using the rotary knob or the arrow key.
2.
Press [ENTER].
A selection window will appear.
3. Locate the cursor to “NonDISPLAY” by using the rotary knob or [S] / [T].
4. Press [ENTER] to register the change made to the grid setting.
The change will not be registered if [ESC] is pressed instead of [ENTER].
NonDISPLAY Hides the grid.
Selectable
grid settings
*DISPLAY Shows the grid.
*: Indicates the default setting.
TIP
Caution
To Next Page
Loading...
