Zebra DS4308 - Snapshot Mode Timeout

5 - 8 DS4308/DS4308P Digital Scanner Product Reference Guide
Snapshot Mode Timeout
Parameter # 323 (SSI # F0h 43h)
This parameter sets the amount of time the digital scanner remains in Snapshot Mode. The digital scanner
exits Snapshot Mode when you pull the trigger, or when the Snapshot Mode Timeout elapses. To set this
timeout value, scan the Set Snapshot Mode Timeout bar code below followed by a bar code from Appendix
G, Numeric Bar Codes. The default value is 0 which represents 30 seconds; values increment by 30. For
example, 1 = 60 seconds, 2 = 90 seconds, etc.
To quickly re-set the default timeout to 30 seconds, scan the 30 Seconds bar code below.
If you select No Timeout, the digital scanner remains in Snapshot Mode until you pull the trigger.
Set Snapshot Mode Timeout
*30 Seconds
No Timeout