Zebra DS4308 - Low Power Mode

4 - 16 DS4308/DS4308P Digital Scanner Product Reference Guide
Low Power Mode
Parameter # 128
(SSI # 80h)
Enable this parameter to reduce power consumption if the scanner is idle for the period defined in Time Delay
to Low Power Mode on page 4-17. Once in Low Power Mode, the scanner wakes upon a trigger pull or when
the host attempts to communicate with the scanner. If disabled, power remains on after each decode attempt.
NOTE The Low Power Mode feature only applies for non-USB and non-RS485 host interfaces, and when
Hand-Held Trigger Mode on page 4-19 is set to Level (Standard).
*Disable Low Power Mode
(0)
Enable Low Power Mode
(1)