User Preferences & Miscellaneous Options 4 - 15
Night Mode Trigger (DS4308-HC Only)
Parameter # 1215 (SSI # F8h 04h BFh)
Enable this to use the trigger to toggle between entering and exiting Night Mode. To toggle, point the scanner
away from a bar code, pull the trigger until the beam goes off, and then continue pulling the trigger for an
additional 5 seconds. Note that pulling the trigger an additional 5 seconds after decoding a bar code has no
affect.
When entering Night Mode, the pager motor vibrates. When exiting Night Mode, the scanner emits 2 short
beeps.
Night Mode Toggle (DS4308-HC Only)
To toggle between entering and exiting Night Mode without using the trigger, scan this bar code. This functions
regardless of the state of the Night Mode Trigger parameter.
When scanning this bar code, the pager motor vibrates when entering Night Mode, and the scanner emits 2
short beeps when exiting Night Mode.
*Enable Night Mode Trigger
(1)
Disable Night Mode Trigger
(0)
Toggle Night Mode
To Next Page
Loading...
