Zebra DS4308 - RTS Line State; Beep on <BEL>

RS-232 Interface 8 - 17
RTS Line State
This parameter sets the idle state of the Serial Host RTS line. Scan a bar code below to select Low RTS or
High RTS line state.
Beep on <BEL>
If you enable this parameter, the digital scanner issues a beep when it detects a <BEL> character on the
RS-232 serial line. <BEL> indicates an illegal entry or other important event.
* Host: Low RTS
Host: High RTS
Beep On <BEL> Character
(Enable)
* Do Not Beep On <BEL> Character
(Disable)