Name: Zebra DS4308
Brand: Zebra
Rating: 4 (1 reviews)

To Next Page

To Previous Page

8 - 16 DS4308/DS4308P Digital Scanner Product Reference Guide

Host Serial Response Time-out

This parameter specifies how long the digital scanner waits for an ACK, NAK, or CTS before determining that a

transmission error occurred. This only applies when in one of the ACK/NAK software handshaking modes, or

RTS/CTS hardware handshaking mode.

* Minimum: 2 Sec

Low: 2.5 Sec

Medium: 5 Sec

High: 7.5 Sec

Maximum: 9.9 Sec

DS4308/DS4308P Product Reference Guide1
- Warranty5
- Revision History6
Table of Contents7
About This Guide19
- Introduction19
- Configurations19
- Chapter Descriptions20
- Notational Conventions21
- Related Documents22
- Service Information22
Getting Started23
- Introduction23
- Interfaces24
- Unpacking24
- Setting Up the Digital Scanner25
- Accessories27
Data Capture29
- Introduction29
- Beeper Definitions30
- LED Definitions32
- Scanning34
- Decode Ranges41
Maintenance & Technical Specifications43
- Introduction43
- Maintenance43
  - General Scanner Maintenance43
  - Healthcare Scanner Maintenance43
- Troubleshooting45
  - Report Software Version Bar Code48
- Technical Specifications49
- Digital Scanner Signal Descriptions51
User Preferences & Miscellaneous Options53
- Introduction53
- Scanning Sequence Examples54
- Errors While Scanning54
- User Preferences/Miscellaneous Options Parameter Defaults54
- User Preferences57
- Miscellaneous Scanner Parameters92
Imaging Preferences101
- Introduction101
- Scanning Sequence Examples102
- Errors While Scanning102
- Imaging Preferences Parameter Defaults102
- Imaging Preferences104
USB Interface125
- Introduction125
- Connecting a USB Interface126
- USB Parameter Defaults128
- USB Host Parameters129
- ASCII Character Set for USB142
SSI Interface153
- Introduction153
- Communications153
- SSI Transactions155
  - General Data Transactions155
  - Transfer of Decode Data156
- Communication Summary157
- Things to Remember When Using SSI Communication158
- Using Time Delay to Low Power Mode with SSI159
- Encapsulation of RSM Commands/Responses over SSI160
- Simple Serial Interface Default Parameters162
- SSI Host Parameters163
- Event Reporting173
RS-232 Interface175
- Introduction175
- Connecting an RS-232 Interface176
- RS-232 Parameter Defaults177
- RS-232 Host Parameters178
- ASCII Character Set for RS-232194
IBM 468X / 469X Interface199
- Introduction199
- Connecting to an IBM 468X/469X Host200
- IBM Parameter Defaults201
- IBM 468X/469X Host Parameters202
Keyboard Wedge Interface205
- Introduction205
- Connecting a Keyboard Wedge Interface206
- Keyboard Wedge Parameter Defaults207
- Keyboard Wedge Host Parameters208
- ASCII Character Set for Keyboard Wedge215
Symbologies225
- Introduction225
- Scanning Sequence Examples225
- Errors While Scanning226
- Symbology Parameter Defaults226
- Enable/Disable All Code Types232
- UPC/EAN233
  - Enable/Disable UPC-A233
  - Enable/Disable UPC-E233
  - Enable/Disable UPC-E1234
  - Enable/Disable EAN-8/JAN-8234
  - Enable/Disable EAN-13/JAN-13235
  - Enable/Disable Bookland EAN235
  - Decode UPC/EAN/JAN Supplementals236
  - User-Programmable Supplementals239
  - UPC/EAN/JAN Supplemental Redundancy240
  - UPC/EAN/JAN Supplemental AIM ID Format241
  - UPC Reduced Quiet Zone242
  - Transmit UPC-A Check Digit242
  - Transmit UPC-E Check Digit243
  - Transmit UPC-E1 Check Digit243
  - UPC-A Preamble244
  - UPC-E Preamble245
  - UPC-E1 Preamble246
  - Convert UPC-E to UPC-A247
  - Convert UPC-E1 to UPC-A247
  - EAN-8/JAN-8 Extend248
  - Bookland ISBN Format248
  - UCC Coupon Extended Code249
  - Coupon Report249
  - ISSN EAN250
- Code 128251
  - Enable/Disable Code 128251
  - Set Lengths for Code 128251
  - Enable/Disable GS1-128 (formerly UCC/EAN-128)253
  - Enable/Disable ISBT 128253
  - ISBT Concatenation254
  - Check ISBT Table255
  - ISBT Concatenation Redundancy255
  - Code 128 Security Level256
  - Code 128 Reduced Quiet Zone257
  - Ignore Code 128 <FNC4>257
- Code 39258
  - Enable/Disable Code 39258
  - Enable/Disable Trioptic Code 39258
  - Convert Code 39 to Code 32259
  - Code 32 Prefix259
  - Set Lengths for Code 39260
  - Code 39 Check Digit Verification261
  - Transmit Code 39 Check Digit261
  - Code 39 Full ASCII Conversion262
  - Code 39 Security Level263
  - Code 39 Reduced Quiet Zone264
- Code 93265
  - Enable/Disable Code 93265
  - Set Lengths for Code 93265
- Code 11267
  - Code 11267
  - Set Lengths for Code 11267
  - Code 11 Check Digit Verification269
  - Transmit Code 11 Check Digits270
- Interleaved 2 of 5 (ITF)271
  - Enable/Disable Interleaved 2 of 5271
  - Set Lengths for Interleaved 2 of 5271
  - I 2 of 5 Check Digit Verification273
  - Transmit I 2 of 5 Check Digit274
  - Convert I 2 of 5 to EAN-13274
  - I 2 of 5 Security Level275
  - I 2 of 5 Reduced Quiet Zone276
- Discrete 2 of 5 (DTF)277
  - Enable/Disable Discrete 2 of 5277
  - Set Lengths for Discrete 2 of 5277
- Codabar (NW - 7)279
  - Enable/Disable Codabar279
  - Set Lengths for Codabar279
  - CLSI Editing281
  - NOTIS Editing281
  - Codabar Upper or Lower Case Start/Stop Characters Detection282
- MSI283
  - Enable/Disable MSI283
  - Set Lengths for MSI283
  - MSI Check Digits285
  - Transmit MSI Check Digit(s)285
  - MSI Check Digit Algorithm286
- Chinese 2 of 5287
  - Enable/Disable Chinese 2 of 5287
- Matrix 2 of 5288
  - Enable/Disable Matrix 2 of 5288
  - Set Lengths for Matrix 2 of 5288
  - Matrix 2 of 5 Check Digit290
  - Transmit Matrix 2 of 5 Check Digit290
- Korean 3 of 5291
  - Enable/Disable Korean 3 of 5291
- Inverse 1D292
- GS1 DataBar293
  - GS1 DataBar-14293
  - GS1 DataBar Limited293
  - GS1 DataBar Expanded294
  - Convert GS1 DataBar to UPC/EAN294
  - GS1 DataBar Limited Security Level295
- Composite296
  - Composite CC-C296
  - Composite CC-A/B296
  - Composite TLC-39297
  - UPC Composite Mode297
  - Composite Beep Mode298
  - GS1-128 Emulation Mode for UCC/EAN Composite Codes298
- 2D Symbologies299
  - Enable/Disable PDF417299
  - Enable/Disable MicroPDF417299
  - Code 128 Emulation300
  - Data Matrix301
  - Data Matrix Inverse301
  - GS1 Data Matrix302
  - Maxicode302
  - QR Code303
  - GS1 QR303
  - MicroQR304
  - Aztec305
  - Aztec Inverse305
  - Han Xin306
  - Han Xin Inverse306
- Postal Codes307
  - US Postnet307
  - US Planet307
  - Transmit US Postal Check Digit308
  - UK Postal308
  - Transmit UK Postal Check Digit309
  - Japan Postal309
  - Australia Post310
  - Australia Post Format311
  - Netherlands KIX Code312
  - USPS 4CB/One Code/Intelligent Mail312
  - UPU FICS Postal313
  - Mailmark313
- Symbology-Specific Security Levels314
  - Redundancy Level314
  - Security Level316
  - 1D Quiet Zone Level317
  - Intercharacter Gap Size318
- Report Version318
- Macro PDF Features319
  - Flush Macro Buffer319
  - Abort Macro PDF Entry319
Intelligent Document Capture321
- Introduction321
- The IDC Process321
- PC Application and Programming Support323
- Parameters324
- Quick Start337
OCR Programming341
- Introduction341
- OCR Parameter Defaults342
- OCR Programming Parameters343
Driver’s License Set Up (DS4308-DL)373
- Introduction373
- Driver’s License Parsing374
- Parsing Driver’s License Data Fields (Embedded Driver's License Parsing)375
- User Preferences389
- Parsing Rule Example411
  - Embedded Driver's License Parsing ADF Example415
123Scan2417
- Introduction417
- Communication with 123Scan2417
- 123Scan2 Requirements418
- Scanner SDK, Other Software Tools, and Videos418
Advanced Data Formatting419
- Introduction419
Standard Default Parameters421
Country Codes435
- Introduction435
- USB and Keyboard Wedge Country Keyboard Types (Country Codes)436
Country Code Pages451
- Introduction451
- Country Code Page Defaults451
- Country Code Page Bar Codes455
CKJ Decode Control465
- Introduction465
- CJK Control Parameters466
- Unicode/CJK Decode Setup with Windows Host471
Programming Reference475
- Symbol Code Identifiers475
- AIM Code Identifiers477
Sample Bar Codes483
- Code 39483
- UPC/EAN483
  - UPC-A, 100%483
  - EAN-13, 100%484
- Code 128484
- Interleaved 2 of 5484
- GS1 DataBar-14485
- PDF417485
- Data Matrix485
- Maxicode485
- QR Code486
- US Postnet486
- UK Postal486
Numeric Bar Codes487
- Numeric Bar Codes487
- Cancel488
ASCII Character Sets489
Communication Protocol Functionality501
- Functionality Supported via Communication (Cable) Interface501
Signature Capture Code503
- Introduction503
- Code Structure503
  - Signature Capture Area503
  - CapCode Pattern Structure504
- Start / Stop Patterns504
- Dimensions505
- Data Format505
- Additional Capabilities506
- Signature Boxes506
Index507

Other manuals for Zebra DS4308

Quick Start Guide20 pages

Reference Guide436 pages

Questions and Answers:

Need help?

Do you have a question about the Zebra DS4308 and is the answer not in the manual?

Zebra DS4308 Specifications

General

Sealing	IP42
Connectivity	USB, RS232, Keyboard Wedge, TGCS (IBM) 46XX over RS485
Decode Capability	1D, 2D, PDF417
Drop Specification	Withstands multiple 1.5 m (5 ft) drops to concrete
Operating Temperature	32° to 104° F/0° to 40° C
Storage Temperature	-40° to 158° F/-40° to 70° C
Humidity	5% to 95% (non-condensing)
Weight	5.7 oz./161.9 g
Dimensions	6.5 in. H x 2.6 in. W x 3.6 in. D 16.5 cm H x 6.6 cm W x 9.1 cm D