Zebra DS4308 - Setting Up the Digital Scanner; Installing the Interface Cable

Getting Started 1 - 3
Setting Up the Digital Scanner
Installing the Interface Cable
1. Insert the interface cable modular connector into the interface cable port on the rear of the digital scanner
until you hear a click. For the DS4308P, tip the scanner forward in its base to best access the port.
Low/medium/high beeps sound, indicating the scanner is operational.
Figure 1-2 Installing the Cable - DS4308 and DS4308P
2. Gently tug the cable to ensure the connector is secure.
3. Connect the other end of the interface cable to the host (see the specific host chapter for information on
host connections).
Interface cable
modular connector
To host
Cable interface port
Interface cable modular
connector clip
IMPORTANT Insert the cable into the cable interface port until a click sounds.
When connecting the DS4308 using a USB cable, a shielded connector cable is required (e.g., p/n
CBA-U21-S07ZAR). If upgrading an LS2208 or LS4208 to a DS4308, use the shielded connector
cable.