108 CHAPTER 4: PLANNING THE 3COM MOBILITY SYSTEM
6 In the Skip Floor Levels box, specify floor numbers you want to skip.
Skipping floors is useful when you want to model only certain floors in a
building. To enter a list of floors, use commas to separate the floor
numbers (example: 1,3,7). To enter a range, use a hyphen (example:
8-12).
7 Do one of the following:
■ Click Apply Changes to apply the numbering changes to the plan.
■ Click Ignore Changes to clear the changes without applying them.
8 Do one of the following:
■ Click the Floor Defaults tab to change the default values for unit of
measurement, ceiling height, and attenuation caused by ceilings. See
“Modifying Floor Defaults”.
■ Click Next to configure floor information for the building. (See
“Importing or Drawing Floor Details”.)
■ Click Finish to close the wizard and save the changes.
Modifying Floor
Defaults
3WXM applies the following values to each floor by default. The defaults
apply to all floors in the building plan.
■ Unit of measurement is in feet.
■ Ceiling height is 10 feet.
■ Ceilings have attenuation of 10 dB for 802.11b/g and 802.11a.
1 In the Building wizard, click the Floor Defaults tab. The floor default
settings appear.
To Next Page
Loading...
