Defining a Mobility Domain 91
The traffic typically sent between WX switches within a Mobility Domain
uses IP/UDP protocol 17 traffic on port 8817 for both source and
destination. Roaming traffic uses IP protocol 4.
Creating a Mobility
Domain
To create a mobility domain, follow these steps.
1 Access the Mobility Domain wizard by doing one of the following:
■ In the main 3WXM window, select Edit > Insert > Mobility Domain.
■ In the Network Plan wizard, click Mobility Domain at the top of the
wizard, then click New Mobility Domain.
2 In the Mobility Domain Name box, type the name for the Mobility
Domain (1 to 16 characters, with no spaces or tabs).
3 In the Seed Member list, select the WX switch that is the seed member.
Only a WX in the Mobility Domain can be specified as a seed member. If
the only value in the list is Not Assigned, you can finish creating the
Mobility Domain now and specify the seed switch later after you
configure or import WX switches.
To Next Page
Loading...
