212 CHAPTER 5: CONFIGURING WX SYSTEM AND ADMINISTRATIVE PARAMETERS
2 Select Enabled to enable HTTPS access, or clear Enabled to disable
HTTPS access.
3 Do one of the following:
■ Go to “Configuring Telnet”.
■ Select another item in the WX Switch wizard, if you are using this
wizard.
■ Click Finish to close the wizard and save changes.
Configuring Telnet To configure Telnet access to the WX:
1 Do one of the following:
■ Open the WX Switch wizard, then select HTTPS, Telnet, SSH & Web
Auth under Management Services in the organizer list of the System
and Administrative page.
To Next Page
Loading...
