284 CHAPTER 6: CONFIGURING WIRELESS PARAMETERS
3 Modify connection parameters:
a To change the WX switch for the connection, select the WX switch
from the WX listbox.
b To change the MAP port number or Distributed MAP connection
number, select the new value from the Port or DAP Number listbox.
c To change the connection bias, select the new value form the Bias
listbox.
d To add the MAP to a MAP group for session load balancing, type the
group name in the Load Balance Group box.
4 Click Finish to close the dialog.
5 Click Finish again to save the changes and close the Modify MAP or
Modify Distributed MAP wizard.
Configuring
Distributed MAP
Access Points
A MAP can connect to the wired network through a direct 10/100
Ethernet connection to a WX or indirectly through other Layer 2 or
Layer 3 wired networking devices. Configure a Distributed MAP for each
indirectly connected MAP.
To Next Page
Loading...
