480 CHAPTER 11: DETECTING AND COMBATTING ROGUE DEVICES
To remove an address
from the known
address list
To remove an address from the known address list, use the following
procedure.
1 In the Organizer panel, click on the plus sign next to a Mobility Domain
name to display the objects in the domain.
2 Click next to the plus sign by Rogue Detection.
3 Click next to the plus sign by Known Addresses. The MAC addresses
(BSSIDs) in the known address list appear.
4 Right-click on the address and select Delete.
The address is removed from the known address list. If the device is
detected by rogue detection, the device appears in the rogue list. Set the
display filter of the Rogue Detection tab to Current and click the Refresh
option on the tab’s toolbar.
Converting a Rogue
into a Third Party
AP
If a device in the rogue list belongs to a third-party AP in your network,
you can convert the rogue into a third-party AP. When you convert a
rogue into a third-party AP, the rogue disappears from the rogue list.
Converting a rogue into a third-party AP applies only to the network plan,
in 3WXM. 3WXM does not send this information in any form to the WX
switches in the network. To prevent MSS from issuing countermeasures
against a third-party AP, you must also add the AP to the known address
list. 3WXM does send the known address list to the WX switches in the
network.
To convert a rogue
into a third-party AP
To convert a rogue into a third-party AP, use the following procedure.
1 Select the rogue in the rogue list.
2 Click Create Third Party AP on the toolbar. The Modify AP wizard
appears.
To Next Page
Loading...
