Configuring a Radio Profile 271
To configure
RF Auto-Tuning
To configure RF Auto-Tuning, use the following procedure.
1 In the Create Radio Profile wizard, click Auto-Tune. The Auto-Tune page
appears.
2 To enable automatic configuration and tuning of the transmit power,
select Yes next to Tune Transmit Power. This feature is disabled by
default.
3 To change the interval at which RF Auto-Tuning decides whether to
change the power level on radios, change the value in the Tx. Power
Tuning Interval box. You can specify from 1 to 65535 seconds. The
default is 300 seconds.
4 To change the interval at which radios reduce power after temporarily
increasing the power to maintain the minimum data rate for an
associated client, change the value in the Tx. Power Backoff Timer box.
At the end of each power-backoff interval, radios that temporarily
increased their power reduce it by 1 dBm. The power backoff continues
in 1 dBm increments after each interval until the power returns to
expected setting.
To Next Page
Loading...
