266 CHAPTER 6: CONFIGURING WIRELESS PARAMETERS
3com recommends that you create a new radio profile and leave the
default radio profile unchanged as a backup.
The default radio profile is associated with a WX switch’s MAPs, unless
you created a new radio profile while configuring a floor plan’s coverage
area and configured the WX switches with the information in the floor
plan.
If you create a new radio profile while configuring a coverage area for a
floor, 3WXM automatically copies the new profile to the domain policy of
the Mobility Domain selected for the coverage area. Later, when you
configure WX switches in the Mobility Domain using the information in
the floor plan, 3WXM also copies the radio profile to the Radio Profiles
policy of each of the WX switches.
To create a radio
profile
To create a radio profile, use the following procedure.
1 Access the WX Switch wizard for the WX switch. (See “Accessing the
Modify Switch Wizard” on page 185.)
2 Select Wireless at the top of the wizard, if not already selected.
3 Select Radio Profile from the organizer list on the left side of the page.
To Next Page
Loading...
