Selecting WX Switches to Monitor 545
12 Add other users if needed, then click Save to save the changes or Cancel
to cancel the changes.
13 Click another tab to configure more settings or click Close to close the
3WXM Services Setup dialog box.
Selecting WX
Switches to
Monitor
You must specify the WX switches you want the service to monitor. You
can add all the WX switches from a Mobility Domain in the network plan
or individual WX switches. The individual WX switches are not required to
be in the network plan.
You also can modify or remove WX switches. In addition, you can enable
SNMP traps on a WX switch and add the monitoring service’s IP address
to the WX switch’s list of trap receivers.
To Next Page
Loading...
