50 CHAPTER 2: WORKING WITH THE 3WXM USER INTERFACE
Table 9 lists the Rogue Detection objects. These objects control
configuration parameters for rogue detection.
Site Objects The Sites section of the Organizer panel contains objects for the buildings
where you want to deploy 3Com equipment. A site can contain one or
more buildings and each building can contain one or more floors. Each
floor contains objects for wiring closets, coverage areas, MAP access
points, and third-party access points.
Table 10 lists the objects in a site.
Spanning Tree
Properties
Same as Management Services in Domain Polices, but
applicable to this WX switch only.
AAA Same as Management Services in Domain Polices, but
applicable to this WX switch only.
802.1X Same as Management Services in Domain Polices, but
applicable to this WX switch only.
ACLs Same as Management Services in Domain Polices, but
applicable to this WX switch only.
Mobility Profiles Same as Management Services in Domain Polices, but
applicable to this WX switch only.
IP Services Same as Management Services in Domain Polices, but
applicable to this WX switch only.
Table 9 Rogue Detection Objects
Object Description
Rogue Detection Setting for countermeasures, which are packets that
3Com radios send to prevent clients from using rogue
access points detected during RF scanning.
Known Addresses List of devices you want WX switches to ignore when
performing rogue detection and issuing countermeasures
against the rogues the WX switches detect.
Table 8 WX Switch Objects (continued)
To Next Page
Loading...
