Configuring Distributed MAP Access Points 285
Table 20 lists how many MAPs you can configure on a WX switch, and
how many MAPs a switch can boot. The numbers are for directly
connected and Distributed MAPs combined.
For a MAP that is directly connected to the WX, configure a MAP port
instead. (For information, see “Configuring Directly Connected MAP
Access Points” on page 274.)
To configure a
distributed MAP
To configure a distributed MAP, use the following procedure.
1 Access the WX Switch wizard for the WX switch. (See “Accessing the
Modify Switch Wizard” on page 185.)
2 Select Wireless at the top of the wizard, if not already selected.
3 Select Distributed MAP from the organizer list on the left side of the
page.
Table 21 Maximum MAPs Supported Per Switch
WX Switch Model
Maximum
Configured
Maximum Booted
WX4400 256 24, 48, 72, or 96,
depending on the
license.
WX1200 30 12
To Next Page
Loading...
