Configuring Directly Connected MAP Access Points 283
To modify a MAP
connection
You can change connection parameters for a MAP, including the WX port
(for directly connected MAPs).
For MAP models that have two Ethernet ports, you also can add or
change the second WX connection for redundancy.
1 On the MAP page of the Wireless page of the WX Switch wizard, select a
MAP port, then click Modify MAP. The Modify MAP wizard appears.
2 Select the connection you want to change and click Modify. The Modify
Direct Connection or Modify Distributed Connection dialog box appears,
depending on the connection type.
Here is an example of the Modify Direct Connection dialog box:
Here is an example of the Modify Distributed Connection dialog box:
To Next Page
Loading...
