422 CHAPTER 10: MONITORING THE NETWORK
Refreshing Client
Data
By default, the data displayed in the Client Monitor window is not
refreshed. You can refresh the data on demand, or automatically at
regular intervals. If you enable automatic data refresh, the data is
refreshed based on the client monitor polling interval specified in the
monitoring service. (See “Changing Monitoring Settings” on page 552.)
To refresh the data on demand
To refresh the data on demand, click the Refresh option on the Client
Monitor window’s toolbar.
To refresh the data automatically
1 Click the checkbox next to Auto Refresh on the Client Monitor window’s
toolbar to enable the option.
2 Click Refresh.
Displaying Client
Activity Information
The Client Activity tab displays current statistics for client activity on the
network. The data fields in the display depend on the scope:
■ If a Mobility Domain is selected, a row of data is displayed for each
WX switch in the Mobility Domain.
■ If a WX switch, MAP access point, or radio is selected, SNMP traps
reported to the monitoring service for that device are displayed.
Data Displayed When the Scope is a Mobility Domain
When a Mobility Domain is selected in the organizer panel, the Client
Monitor window’s Client Activity tab displays a row of information for
each WX switch in the Mobility Domain.
Table 33 lists the data displayed on the Client Activity tab when the scope
is a Mobility Domain. The counters are incremented each time the
monitoring service receives a client activity trap generated by a WX
switch. The counters represent activity for all clients within the selected
scope.read-only
To Next Page
Loading...
