202 CHAPTER 5: CONFIGURING WX SYSTEM AND ADMINISTRATIVE PARAMETERS
To configure IGMP snooping:
1 In the Create VLAN wizard, click VLAN IGMP Setup. The VLAN IGMP
Setup page appears.
2 To enable IGMP snooping, select Enable. To disable IGMP snooping, clear
Enable. By default, IGMP snooping is enabled.
3 In the Version list, select Version 1 or Version 2 of IGMP.
4 If IGMP queriers are not on the subnet (for example, multicast routers),
select Querier Enabled.
3Com recommends that you use the pseudo-querier only when the VLAN
contains local multicast traffic that is not routed.
5 In the Query Interval box, specify the interval (1 to 65,535 seconds) at
which the WX switch sends general IGMP queries on behalf of multicast
routers to advertise multicast groups. The default interval is 125 seconds.
To Next Page
Loading...
