3Com 3CRWX120695A - Page 228

228 CHAPTER 5: CONFIGURING WX SYSTEM AND ADMINISTRATIVE PARAMETERS
2 In the Name box, type the name for the time zone (1 to 16 alphanumeric
characters, with no spaces or tabs).
3 In the Offset Hours box, specify the number of hours (between -23 and
23) to subtract from or add to UTC.
4 Optionally, in the Offset Minutes box, specify the number of minutes
(between -59 to 59) to subtract from or add to UTC.
5 Do one of the following:
■ Go to “To set summertime information”.
■ Select another item in the WX Switch wizard, if you are using this
wizard.
■ Click Finish to close the wizard and save changes.
To set summertime information
1 In the DST Name box, type the name for the summertime offset (1 to 16
alphanumeric characters, with no spaces or tabs).
2 In the Start Month list, select the month of the year when the time
change starts.
3 In the Start Week list, select the week of the month when the time
change starts (First, Second, Third, Fourth, or Last).
4 In the Start Day list, select the day of the week when the time change
starts.
5 In the Start Hour box, specify the hour (between 0 and 23) to start the
time change.
6 In the Start Minute box, specify the minute (between 0 and 59) when the
time change starts.
7 In the End Month list, select the month of the year when the time change
ends.
8 In the End Week list, select the week of the month when the time change
ends (First, Second, Third, Fourth, or Last).
9 In the End Day list, select the day of the week when the time change
ends.
10 In the End Hour box, specify the hour (between 0 and 23) when the time
change ends.
11 In the End Minute box, specify the minute (between 0 and 59) when the
time change ends.