276 CHAPTER 6: CONFIGURING WIRELESS PARAMETERS
4 In the table, enable a port as a MAP port by selecting MAP Enabled for
the port.
If a port is currently configured as a wired authentication port, you are
prompted to choose whether to reconfigure the port.
You can see that the port has been labeled as a MAP port and has PoE
enabled. Enable all ports as MAP ports by selecting MAP Enabled in the
MAP Enabled column heading.
5 Click in the Name column for a MAP port you enabled, and type a name
for it (1 to 16 alphanumeric characters, with no spaces or tabs).
6 To select the MAP type, click on the MAP Type cell for the port. A list of
MAP models appears. In the list, select one of the following:
■ AP2750 — Single-radio model.
■ MP-352 — Dual-radio model.
To Next Page
Loading...
