304 CHAPTER 7: CONFIGURING AUTHENTICATION, AUTHORIZATION, AND ACCOUNTING PARAMETERS
5 In the Name box, type the name of the user (1 to 60 alphanumeric
characters, with no spaces or tabs).
6 In the VLAN Name box, type the name of the VLAN that the user belongs
to (1 to 16 alphanumeric characters, with no spaces or tabs). The WX
switch will authorize the user for that VLAN. For more information on
VLANs, see “Configuring VLANs” on page 188.
If the user requires administrative access only, you do not need to specify
a VLAN.
7 In the Password box, type the password for the user (1 to 80
alphanumeric characters, with no spaces or tabs). You must specify a
password if you want the password to be encrypted in the configuration
file.
8 To specify that the user password is already encrypted, select
Already Encrypted.
By default, this option is not selected. Do not select this option if you
want the WX switch to encrypt the user password.
9 In the User Group list, select a user group to assign the user to, if the
group is already configured.
You do not need to assign a user to a user group. If you do select a user
group, you only need to specify a password for the user. All other
attributes are obtained from the user group.
To Next Page
Loading...
