ABB PGC5000 Generation 2 - Digital Input; Analog Output

892 J006 MNAH | PGC5000 G EN 2 | 107
5.9.5 Digital input
Figure 5-22 illustrates the Digital I/O display, with a digital input channel selected. The editable areas
are:
⎯ NAME: reference name used for the button name
⎯ STATE: echoes the installed module’s state (red or green indication is dependent on
installation specifications)
⎯ FUNCTION: selected function (affected by state change)
⎯ ASSIGNMENT: assigned schedule for the selected function
Figure 5-22: Digital Input Display
5.9.6 Analog output
Figure 5-23 illustrates the analog I/O display, with an analog output channel selected. The editable
areas are:
⎯ NAME: reference name, used for the button name
⎯ RANGE LOW: analog output low limit
⎯ RANGE HIGH: analog output high limit
⎯ COMPONENT: select the component you want to drive the analog output
⎯ SET VALUE: Used to manually drive a value on the analog output. Normally used for testing
on start-up or during troubleshooting.