892 J006 MNAH | PGC5000 G EN 2 | 57
Too many script TCFs in
[Analysis Name]
The count of the Script TCFs in this Analysis exceeds the maximum limit.
Invalid min Method TCF
StartTime=%d < 0
A TCF at Method scope was found to have a time offset of less than zero
seconds.
Found more than one
Stream Step TCF.
Only one Stream Step is allowed in each Analysis.
More than one Stream Step
TCF in [AnalysisName]
No Analysis can have more than one Stream Step.
Every Analysis must have a Stream Step.
NO TCFs in Analysis:
"[AnalysisName]"
Analysis did not contain any TCFs.
[Method Name] inside prev
Method
An Analysis was found containing a Method having no TCFs nor any
Sequences.
[Sequence Name] in prev
Sequence
An Analysis was found containing a Sequence having no TCFs.
All active STEP table items
have a bad ["Analysis"]
No Schedule Elements in the STEP table were found having a well-
formed Analysis.
[Component Name] - bad
time values
A part of the named Component TCF is outside of its containing Method.
Malformed Method -> no
oven assignment
Every Method must have an Oven Name specified in that Method.
Sequence.TimeOffset >=
Method.CycleTime
No Sequence start time can be greater than the containing Method's
CycleTime.
SkipNextIf is the last TCF in
Analysis
A Skip Next TCF type cannot be the last TCF in an Analysis.
SkipNextIf TCF precedes
Component TCF
A Skip Next If TCF cannot precede Component TCF.
SkipNextIf TCF precedes
DoNextIf TCF
A Do Skip If TCF cannot precede another Do Skip If TCF.
SkipNextIf TCF precedes
TcfSkipNextIf
A Skip Next If TCF cannot precede a Do Next If TCF.
SkipNextIf TCF precedes
UnknownPeak TCF
A Skip Next If TCF cannot precedes an Unknown Peak TCF type.
Malformed Analysis: Startup
purge < 1
An Analysis's Startup Purge must be greater than zero.
[Method Name]:Skip then
StreamStep
In the named Method, a skip occurs before the Stream Step.
SkipNextIf TCF precedes
StreamStep Tcf
A Skip Next If TCF cannot precede a Stream Step TCF.
StreamStep TCF starts at
time < 1 second
A Stream Step TCF cannot start at a time of less than one second into
the CycleTime.
(MaxTcfEndTime = [Secs])
> (CycleTime= [Secs])
Some TCF in the Method exceeded this containing Method's CycleTime.
Not all TCFs have a valid
start time
A TCF's time offset is configured at less than one second before the end
of the Cycle Time. Note one exception: End-Of-Analysis scripts.
1st TCF not starting at
reasonable time
First TCF time offset is configured to start before one second into the
Cycle Time.
Invalid min Seq TCF
StartTime = %d < 0
A TCF at Sequence scope has a time offset of less than zero seconds.
[Description] TCF StartTime
<= 0
No TCFs are allowed to start at a start time of <= '0' (Inside a Method /
Sequence).
Same oven address in 2
Methods found Analysis:
"[AnalysisName]"
In one Analysis, two methods are configured to run in the same oven.
Same Component in two
different Methods
The same Component Name is found in two different Methods.
To Next Page
Loading...
