78 | PGC5000 GEN 2 | 892 J006 MNAH
Figure 4-49: Subscriber Added and Activated example
The following table identifies all events which trigger output to the defined subscriber lists.
Table 4-6: Subscriber descriptions
Trigger/Origination Point
Power Recovery: <DateTime>
Analyzer completes power up sequence
User logs in to the analyzer
User logs out of the analyzer
Stream Online:
<StreamName>
Stream set online manually, programmatically
(via scripting) or automatically (via DCS call
through OPC Server)
Stream Offline:
<StreamName>
Stream set offline manually, programmatically
or automatically
Schedule Run:
<ScheduleName>
Resource Group has been activated manually,
programmatically or automatically
Schedule Stopped:
<ScheduleName>
Resource Group has been deactivated manually,
programmatically or automatically
Schedule Paused:
<ScheduleName>
Resource Group suspended manually,
programmatically or automatically
Schedule has no Analyses to Run
Calibration Started:
<ScheduleName>
Schedule starts calibration
Calibration Competed:
<ScheduleName>
Schedule completes calibration
Validation Started:
<ScheduleName>
Schedule starts validation
Validation Completed:
<ScheduleName>
Schedule completes a validation
Maintenance Started:
<ScheduleName>
Schedule Maintenance Starts: Maintenance
Button Activated
Maintenance Completed:
<ScheduleName>
Schedule Maintenance Ends: Maintenance
Button deactivated
The subscriber list supports failover (redundancy). If the secondary network interfaces are configured,
the system switches to the secondary network and continues to report data if the primary network
fails (activates COM failure indicator).
To Next Page
Loading...
