MODULE 8: CONFIGURATION
8-16 AEROSET
®
Customer Training Guide
94858-103 — July 2003
*The Operator is required to cycle the System power after editing any of
these options.
To configure the RUN OPTIONS and SYSTEM CONFIGURATION
screens:
•Select <RUN> in the Action Area to display the RUN OPTIONS
screen.
• Then, select <SysCfg> to display the SYSTEM
CONFIGURATION screen.
For information about configuration of the System Configuration
options, refer to System Configuration in Section 2, Installation
Procedures and Special Requirements of the AEROSET System
Operations Manual.
SmplSeq
(Sampling
Sequence),
Continued
• In the desired order, repeat the preceding step for all
assays.
• To remove an assay from the sampling sequence,
select the assay in the Sampling Sequence column,
then select <Remove> in the right column of the
Sampling Sequence dialog window.
NOTE: When the Smart Sampling option is
selected, assays defined in SmplSeq are not
acknowledged unless ICT™ assays are defined
in SmplSeq. This allows ICT samples to be
aspirated first while still using the Smart
Sampling option.
Option Description
To Next Page
Loading...