Consumables and Accessories
AEROSET
®
Customer Training Guide 1-23
94858-103 — July 2003
Diluted Wash Solutions must also be prepared to be used for probe
washing. The diluted Wash Solutions are placed in the Reagent Supply
Centers and Calibrator/Control Carousel.
Water Bath Additive
The Water Bath Additive is used to minimize bacterial growth in the
water bath. A supply of the Water Bath Additive is placed in an outer
segment of Reagent Supply Center 1. It is dispensed into the water bath
during the Change Water In Bath Procedure performed during START
UP or SHUTDOWN. Water Bath Additive is ready to use and may
remain onboard until depleted.
Figure 1.15: Water Bath Additive
Calibrators
A variety of calibrators are used on the AEROSET System. Both serum
and aqueous based materials are used. Refer to the assay-specific
Package Inserts to identify the calibrators used for each assay.
• ½ Liter
• Unopened - Store at room
temperature.
125642
• Show MCC’s.
• Show Iron/Mg Calibrators.
Point out values on bottles.
To Next Page
Loading...