Lab Day Activity
AEROSET
®
Customer Training Guide 12-9
94858-103 — July 2003
Starting the Patient Samples
1. You have 10 bar code labeled patient samples to run and one of the
samples is STAT. To run the STAT sample perform the following:
a. Load the STAT sample into the Reserved STAT Position.
b. Select <STAT> from the Information Access Area.
c. Enter the bar code number into the Sample ID field on the
ORDER ASSAYS FOR STAT screen. (Do not order any
assays.)
d. Select <Start> in the right-hand column.
2. Load the remaining routine samples on the FastTrack™ Sampler
and initiate the run using the appropriate procedure for the System
status of your instrument.
Controls Out of Range
1. Review the Start-QC results.
2. Determine the cause of any values that are out of range and rerun the
Start-QC, if necessary.
Manually Enter Priority Orders
1. The Emergency Room sent up four priority samples. Manually enter
these orders to be run in the Sample Carousel. SID is required.
2. Load the samples and initiate the run using the appropriate
procedure for the System status of your instrument.
Name Assays
Kode, Morris ICT™ assays, Glu, Crea, Urea
Kain, Candy ICT™ assays, Iron
Ferterbest, Hope Ca, Phos, ALT, AST
Septic, Anna Glu
To Next Page
Loading...