Installation and User Manual ADPRO FastTrace by Xtralis
126 Doc 11168_12
• If you get bad quality audio from the control room to the site:
- Check the available bandwidth the FastTrace has allowed for the audio at
VideoCentral.
- Check that the cabling from the microphone is shielded and is not going near any
obvious sources of electrical noise (such as monitors).
• If you are getting bad quality audio from the site to the control room:
- Check that the audio cable is not running in the same cable as the power for the
speakers and microphones.
- Make sure that the central station is also capable of connecting into your site, as just
because you can dial out does not mean they can dial in.
• Check that all cameras are recording as expected by reviewing stored video.
• If the Access/Secure or Mode Select Input is being used, ensure that it is wired correctly
and that the FastTrace changes state as expected.
• If backup communications are used, ensure that if the primary communications channel is
not available, that the backup channel works as expected.
To Next Page
Loading...