Installation and User Manual ADPRO FastTrace by Xtralis
18 Doc 11168_12
The screen below is displayed when the installation is complete:
Figure 21: Setup Complete
Note: The PC must be restarted before VideoCentral Lite can be used.
2.7.6 Starting VideoCentral Lite for the First Time
1. Start the VideoCentral Lite program by double-clicking the VideoCentral icon on the
Windows desktop.
If you do not have a VideoCentral dongle (Hardware Protection Key) attached to the PC, the
following screen will appear.
Figure 22: Dongle Required
It is not necessary to have this device attached to perform the setup functions.
2. Click on the Yes button to accept this condition and VideoCentral Lite user interface will be
displayed.
To help users with the first time setup of a FastTrace, a number of default settings are used
in the ADPRO VideoCentral Lite software that must match the default factory settings found
in a new FastTrace unit. The default settings stored in the VideoCentral Lite can be found
by using the following menu:
Database / Administration / Configure Sites / FastTrace default site.
To Next Page
Loading...