Agilent Technologies 1220 Infinity II LC User Manual

48 1220 Infinity II LC System User Manual
3 Installation
Configuration of the Instrument After an Upgrade Installation
Configuration of the Instrument After an Upgrade Installation
This step is only necessary if any of the following hardware upgrade kits has
been installed to the instrument.
• G4297A - 1220 Infinity Oven kit
• G4298A - 1220 Infinity upgrade manual injector to ALS
• G4299A - 1220 Infinity upgrade isocratic to gradient pump
1 Connect the Instrument to the Instrument Utility / Lab Advisor software.
2 Configure your Instrument according to the applied hardware changes:
Software Revision B.01.04 and below:
• Tools > Module Service Center (any module)
Software Revision B.02.01 and higher:
• Instrument Control > Controls (any module) > Convert Device Type
(For example if you installed a G4297A - 1220 Infinity Oven kit then press
Add Oven
3 Disconnect from the software and re-boot your instrument.
4 Re-connect to the Instrument to the Instrument Utility / Lab Advisor
software.
5 Now perform the Installation Check as described in “Priming the System and
Performing the ‘Installation Check’” on page 49.
6 When starting the Chromatographic Data System use Auto Configuration to
have your new hardware configuration configured to the CDS.

Agilent Technologies 1220 Infinity II LC Specifications

General

Brand	Agilent Technologies
Model	1220 Infinity II LC
Category	Laboratory Equipment
Language	English