1220 Infinity II LC System User Manual 45
Installation
3
Connecting the Agilent 1220 Infinity II LC to the PC
Connecting the Agilent 1220 Infinity II LC to the PC
The instrument is delivered from factory with the default network
configuration settings. (Configuration dip switches 7 & 8 set to ON). This
enables you to quickly connect it via the crossover patch cable (part of the
accessory kit) with your PC.
Factory default IP address:
192.168.254.11
Figure 8 Location of the Configuration Dip Switches and LAN Port
On the G4294B use the configuration dip switches of the DAD extension board to
configure your LAN connection.
To Next Page
Loading...
