Agilent Technologies 1220 Infinity II LC User Manual

46 1220 Infinity II LC System User Manual
3 Installation
Connecting the Agilent 1220 Infinity II LC to the PC
1 To connect the instrument with your PC using this default address
configure the PC’s network settings as followed:
2 Connect the crossover patch cable between the LAN-Port of the Agilent
1220 Infinity II LC (Figure 8 on page 45) and the network connector of your
PC.
If you want to connect the instrument to a network we strongly recommend
consulting your local network administrator to provide you with a valid
network address. For further details about LAN configuration of the
instrument please refer to the LAN Configuration section of the Installation
chapter in the user manual.
Here you find details about:
• TCP/IP parameter configuration
• Configuration Switches
• Using a fixed IP address
• How to configure an individual IP address
IP:
192.168.254.10
Subnet Mask:
255.255.255.0
Default Gateway:
N/A
NOTE
The crossover cable is only for the direct connection between the module and the PC. If
you want to connect your Agilent 1220 Infinity II LC via a hub to the network you should
contact your local network administrator.

Agilent Technologies 1220 Infinity II LC Specifications

General

Brand	Agilent Technologies
Model	1220 Infinity II LC
Category	Laboratory Equipment
Language	English