1220 Infinity II LC System User Manual 63
LAN Configuration
4
Configuration Switches
Configuration Switches
The configuration switch can be accessed at the rear left side of the
instrument.
The instrument is shipped with switches 7 and 8 set to ON, which means that
the instrument is set to a default fixed IP address: 192.168.254.11
To configure the LAN, SW1 and SW2 must be set to OFF.
Table 10 Factory Default Settings
Initialization (‘Init’) Mode Using Default, switches 7 and 8 set to ON.
Link Configuration Speed and duplex mode determined by auto-negotiation
For the G4294B, the Configuration switches on the DAD main board must be used for
configuring the LAN access of the instrument. The switches on the main board must all be
set to off.