Cleaning Instructions
410 Agilent 8163A/B, 8164A/B, and 8166A/B User’s Guide, Fourth Edition
The following Cleaning Instructions contain some general safety
precautions, which must be observed during all phases of cleaning.
Consult your specific optical device manuals or guides for full
information on safety matters.
Please try, whenever possible, to use physically contacting connectors,
and dry connections. Clean the connectors, interfaces, and bushings
carefully after use.
If you are unsure of the correct cleaning procedure for your optical device, we
recommend that you first try cleaning a dummy or test device.
Agilent Technologies assume no liability for the customer’s failure to
comply with these requirements.
Cleaning Instructions for this Instrument
The Cleaning Instructions apply to a number of different types of
Optical Equipment. Table 20 lists the sections that are relevant to the
various modules that can be installed in this instrument.
Table 20 Cleaning Instructions for Modules
Modules Instruction
Optical Heads “How to clean instruments with an optical glass plate”
on page 423
Laser Source Modules “How to clean instruments with a physical contact
interface” on page 423
Tunable Laser Modules “How to clean instruments with a physical contact
interface” on page 423
Return Loss Modules “How to clean instruments with a physical contact
interface” on page 423
LED Source Modules “How to clean instruments with a physical contact
interface” on page 423
Power Sensor Modules “How to clean instruments with a recessed lens
interface” on page 424
To Next Page
Loading...
Need help?
General
