80 Agilent 8453 UV-visible Spectroscopy System Operator’s Manual
4 Using your Agilent 8453 UV-visible Spectroscopy System
Entering your Cell’s Path Length
Entering your Cell’s Path Length
The cells used for your measurements are specified with the sampling system
parameters. In quantitative calculations these parameters are used in results
calculation. Due to the freedom of choices for the cell path length, you must
provide the correct value with the path length setting. Usually you get this
information from the supplier of your cells. You so set the path length in
manual mode cell handling as follows.
1 Click Setup on the Instrument Panel.
2 Type the path length in cm in the Setup Manual dialog box.
3 Click OK to set the specified path length.
To Next Page
Loading...
