56 Agilent 8453 UV-visible Spectroscopy System Operator’s Manual
4 Using your Agilent 8453 UV-visible Spectroscopy System
Starting Your First Measurement Session
Starting Your First Measurement Session
1 Make sure that your Agilent 8453 UV-visible system has been installed
correctly.
For details of installation see your Installing Your UV-visible Spectroscopy
System manual.
2 Switch on your PC, monitor and printer.
3 Log on to your PC operating system.
Check your Agilent BootP Service is running using the Control Panel’s
Administrative Tools Services dialog or make sure that your network
administrator has integrated your Agilent 8453 spectrophotometer into
your local network.
4 Switch on your Agilent 8453 spectrophotometer.
A running BootP service will now assign the configured IP address to your
spectrophotometer. In the standard installation the Agilent BootP Service
performs this task.
5 Start your measurement session by selecting Instrument 1 online from the
menu.
Your Instrument Panel shows you the current state of the
spectrophotometer and the Blank button is enabled.
To Next Page
Loading...
Need help?
General
