Installer manual AlphaVision ML Rev. 3.60 01-01-2015 81
Protocol
In this programming option the protocol (Speech/Siren/SMS) is programmed which is used for reporting to a
private telephone. This option is programmable for each of the four telephone numbers. With a PSTN or
GSM plug-on board, the options Siren and SMS can be selected. When the AlphaVision ML also uses a
speech plug-on board, the option ‘Speech’ can be selected.
From firmware V3.2 the 'Email' option is added as a protocol for private reporting. For each private number
(1-4) the protocol option 'Email' can be chosen to ensure that alarm and status messages are sent to the
email address of the called party. In the programming option "Email recipient" the email address of the
receiving party can be programmed.
►! For email notification some basic settings must also be programmed, these can be found in the
Dialer section - LAN / GPRS - Diverse LAN / GPRS settings.
Dial attempts
In this programming the number of dial attempts (0-9) for each private telephone number is programmed.
►! When the user disarms the system within 20 seconds after an alarm, the calling cycle will stop
immediately!
Stop dial sequence for private reporting (v2.00 and higher)
The dialing sequence for reporting to private (mobile) phone numbers will be stopped immediately once the
system is disarmed. This is to prevent that friends, family and neighbors are called due to a false alarm or an
alarm caused by a user error. Stopping the dialing sequence applies only for private reporting using analog
(PSTN) or GSM.
Alarm messages
In this programming menu you can program which types of messages are sent to the central station and/or
private telephones. This programming menu is also used for programming settings for the test report to the
central station. The following options can be changed:
Central station messages
Private telephone messages
Test report
Time test report
Central station messages
This menu option allows for programming which types of messages will be reported to the central station.
The messages are divided into three categories:
Alarm messages and social alarms (ALARMS)
Alerts and system messages (ALERTS)
Arming/ disarming messages (OPEN/CLOSE)
The following options can be programmed:
ALL MESSAGES (alarms, social alarms, system messages and arming/disarming messages)
ALARMS & ALERTS. (alarms, social alarm and system messages)
ALARMS & ARM/DIS. (alarms, social alarm and arming/disarming messages)
ALARMS (alarms only)
ARM/DISARM (arming/disarming messages only)
ALERTS (system messages only)
NO MESSAGES (no messages sent)
To Next Page
Loading...