alphatronics AlphaVision ML - DEFAULT PROGRAMMING; Default Codes and Settings Summary

Installer manual AlphaVision ML Rev. 3.60 01-01-2015 105
DEFAULT PROGRAMMING ALPHAVISION ML
The control panel is supplied with the following default programming:
Codes
Installer code : 123456
Supervisor code (90) : 445566
Codes 1 to 89 : Not programmed
Duress code : for all codes, add 1 to the last digit (when allowed in programming)
Download code : 000000
Telephone numbers : Not programmed
Protocol : SIREN
Dial attempts : DO NOT DIAL
Installation menu
Inputs
Zone names : NOT PROGRAMMED
Zone types : Zones 1 to 44 all INSTANT
Zone options : Doorbell – Zone 1 to 44 all OFF
: Bypass – Zone 1 - NO, Zones 2 to 44 - YES
: Zone sections – Zone 1 t/m 44 Section 1…
: Inactivity – Zones 1 to 44 OFF
Zone characteristics : Zone 1 to 44 – NOT ACTIVE
Outputs
LS : YES
Entry buzzer : KEYPADS 1 to 8 – ENTRY/EXIT
Trouble buzzer : KEYPAD 1 to 8 - ON
Output 1-8 : ALARM
System
Quick arming : NO
Bypass : NO
Auto reset : RESET AFTER 3 TIMES
Panic alarm : OFF
Duress code : NO
Partial arm : Sections 12
Complete (total) arm : Sections 1234
Aux button : STATUS
LCD backlight : OFF AFTER 20 SECONDS
Arm/Disarm in log : YES
Configuration : KEYPADS - 1, I/O-MODULES - NONE, PROXREADER - NONE
Jamming : NO
House ID : ALPHAVISION ML
User codes : 6-digit
Entry/Exit mode : EN50131
LS on walktest : No
Superv. Loudalrm : Loud alarm
LS on doorbell : Not active
TIMERS
Alarm restore : 30 seconds
Inactivity : 24 hours (off)
Supervision : 8 hours