alphatronics AlphaVision ML - Maintenance

Installer manual AlphaVision ML Rev. 3.60 01-01-2015 95
When using the optional speech plug-on board, the AlphaVision ML can also report using pre-recorded
speech messages. The receiving party can confirm the alarm message by pressing:
 Key 9: Acknowledge the message and disconnect
When using the speech plug-on board and reporting with the Speech message protocol, the called party will
hear a house Identity (if recorded), followed by the speech messages indicating which event occurred in
which zone. Finally, the system status is reported. Besides confirming the alarm message with key <9>, a
number of other options are also possible:
 Key 4: Partial arming
 Key 5: Request system status
 Key 6: Complete (Total) arming
 Key 7: Activate output (latch or pulse)
 Key 8: Deactivate output (latch) or activate output (pulse)
 Key 9: Acknowledge the message and disconnect
 Key 0: Disarm control panel
►! Keep in mind that the AlphaVision ML, when calling to a private telephone, does not require a valid
user code for arming Partial, Total arming and disarming. Make sure that the private telephone
numbers used are only of authorized contact persons!
When the AlphaVision ML control panel is equipped with both a speech plug-on board as well as a keypad
with integrated speaker and microphone or a speakerphone the called party can activate a semi-duplex
speech/listen-in session. The AlphaVision ML automatically starts in the listen-in mode. Use the following
keys on the telephone for this function:
Key 1: Listen-in
Key 2: Speak
Key 4: Partial arming
Key 5: Request system status
Key 6: Complete (Total) arming
Key 7: Activate output (latch or pulse)
Key 8: Deactivate output (latch) or activate
output (pulse)
Key 9: Accept alarm message and disconnect
Key 0: Disarm control panel
►! Keep in mind that the AlphaVision ML, when calling to a private telephone, does not require a valid
user code for arming Partial, Total arming and disarming. Make sure that the private telephone
numbers used are only of authorized contact persons!
MAINTENANCE
The Maintenance menu offers several functions used for periodic checking and servicing of the system. The
following options are available:
 View open zones
 Walktest
 Walktest zone
 Test LED’s and LCD
 Test outputs
 Reset user code
 Default factory settings
 Connect via IP
 Send Testreport