Personnel and Equipment Safety Information
This section describes important safety information to avoid personal injury and damage to the equipment
while installing, operating, maintaining, or servicing the equipment. All safety regulations, standards, and
procedures at the analyzer location must be followed.
All personnel involved with the installation, start-up, operation, maintenance, service, or troubleshooting
of the IPS-4 Analyzer must review and follow these Warnings and Cautions.
Warnings
Review and follow these Warnings to avoid personal injury or environmental contamination.
Always disconnect main AC power and/or external power sources to the analyzer before
opening any covers or doors on the analyzer to check or perform maintenance on any compo-
nents within the enclosures.
If it is necessary to open the analyzer’s covers or doors while the circuits are live, test the
area for ammable gases (and proceed only when the area is safe).
Purged Analyzer (Hazardous Location) Applications
To work on the analyzer with it powered up and its Electronics Enclosure door open, the
Purge Bypass Switch must be in the “BYPASS” position.
When the Electronics Enclosure door is open, take appropriate precautions to avoid electrical
shock. Hazardous voltages are present inside.
All electrical connections, adjustments, or servicing of the analyzer should be performed only
by properly trained and qualied personnel.
All electrical connections, materials, and methods (plus all safety policies and procedures)
must be made in compliance with local wiring regulations and electrical code for the hazard-
ous area.
Follow appropriate regulatory and/or company procedures to lock out the analyzer while
working on the analyzer electronics.
Before working on the sample system, conrm that the system has been purged with Zero uid
and is isolated (blocked in) from the process.
!
WARNING
!
WARNING
!
WARNING
!
WARNING
x | IPS-4 Dual Bench (UV / IR) Analyzer
To Next Page
Loading...
Need help?
General
