Controller / User Interface | 4-33
Diagnostics Screen
The Diagnostics screen (Figure 4-25) allows the user to disable normal
operations while troubleshooting or setting up external control systems.
Figure 4-25.
Diagnostics Screen.
Diagnostics
►Current Output Diagnostics
Relay Diagnostics
Valve Diagnostics
Lamp Diagnostics
UV Diagnostic
IR Diagnostic
HOME ALARMS STATUS SETUP
Figure 4-27.
Current Output
Diagnostics Screen.
Current Output 1 Diagnostics
►Diagnostics State O
Current Output 1 61%
Type 4-20 mA
Over Range
Disabled
HOME ALARMS STATUS SETUP
Figure 4-26.
Current Output
Diagnostics Screen.
Current Output Diagnostics
> Current Output 1 Diagnostics
Current Output 2 Diagnostics
Current Output 3 Diagnostics
Current Output 4 Diagnostics
HOME ALARMS STATUS SETUP
Current Output Diagnostics
Test analog outputs.
Relay Diagnostics
Force relay contacts on or off to test the hardware.
Figure 4-28.
Relay Diagnostics
Screen.
Relay Diagnostics
►Diagnostics State O
Relay 1 On
Relay 2 On
Relay 3 On
Relay 4 On
HOME ALARMS STATUS SETUP
To Next Page
Loading...
Need help?
General
