Maintenance and Troubleshooting | 5-31
Analyzer Reset
If a situation arises where the analyzer must be reset, take appropriate
safety precautions power down the analyzer using the power-disconnect
switch (breaker). Reapply power.
Do not randomly reset the analyzer during normal operation. Typical-
ly, a reset is required only when analyzer configuration settings have
been restored. In this case the analyzer will reset itself automatically
upon power-up, and will enable the restored settings.
!
CAUTION
Figure 5-4.
Over-Temperature
alarm Reset Switch
(S501), Relay board
(100-2050).
To Next Page
Loading...
