Ametek IPS-4

5-30 | IPS-4 Dual Bench (UV / IR) Analyzer
Condition/Alarm Name Description and Suggested Corrective Action

This alarm condition occurs if the Relay board cannot communicate with
the MCU board due to incompatible rmware versions.
Corrective Action:
The Relay board and/or MCU board rmware will have to be replaced:
• Contact AMETEK for assistance.

This alarm condition occurs if the Display board cannot communicate
with the MCU board due to incompatible rmware versions.
Corrective Action:
The Display board and/or MCU board rmware will have to be replaced:
• Contact AMETEK for assistance.
File system error This alarm condition occurs if the Detector data le (also known as the
DSP, or digital signal processing, le) is missing or has become corrupt.
Corrective Action:
• Contact AMETEK for assistance.
Calibration Required This warning is generated after a span calibration failure or a zero
calibration failure.
Corrective Action:
Perform a successful span calibration:
• Contact AMETEK for assistance.
Zero Cal Required This warning is generated after a zero calibration failure or if a zero has
not been performed.
Corrective Action:
Perform a successful zero calibration:
• Contact AMETEK for assistance.
Zero Cal Failure This warning is generated after a zero calibration failure.
Corrective Action:
Perform a successful zero calibration:
• Contact AMETEK for assistance.
Span Cal Failure This warning is generated after a span calibration failure.
Corrective Action:
Perform a successful span calibration:
• Contact AMETEK for assistance.