6-4 | IPS-4 Dual Bench (UV / IR) Analyzer
Recommended Spare Parts
This section lists the spare parts to have on-site for the IPS-4 Analyzer,
some that are required as part of as analyzer preventive maintenance (see
“Analyzer Preventive Maintenance Schedule” in Chapter 5).
Content is subject to change without notice.
Measuring Cell Assembly Spare Parts
Measuring Cell spare parts that are required as part of the “Analyzer
Preventive Maintenance Schedule” for your analyzer vary, depending
on the application. AMETEK recommends having this part available, to
ensure your analyzer will operate at peak efficiency.
Before ordering spare parts for the Measuring Cell, refer to the
“Supplemental Information” section of this manual or the Documentation
Package shipped with the analyzer for a Measuring Cell Manual
Supplement or a Custom Spare Parts List. If the Cell maintenance procedure
is described in a separate Manual Supplement, check that document first for
a Spare Parts list. If included, use those part numbers; if not, use the part
numbers listed in the Custom Spare Parts List.
Optical Bench Assembly Spare Parts
* Xenon Flash Lamp and Infrared Source life expectancy is 3–5 years;
therefore, only a 3-year quantity is included in this list.
Optical Bench Assembly, Preventive Maintenance Spare Parts
Qty
Part No. Description (3 Year)
100-2761 Xenon Flash Lamp Assembly (Tested) 1*
(Optical Bench) (see Note, above)
100-2847 Infrared Source Assembly (Emitter 897C 2.38W) 1*
(Optical Bench)
NOTE
NOTE