4-10 | IPS-4 Dual Bench (UV / IR) Analyzer
When an alarm or warning is set by the analyzer, the message will flash
on the HOME screen only. The information on the HOME screen will be
replaced by a reverse (white) screen with the alarm name in black text.
It will then switch to a black screen with white text and will continue to
flash until the alarm conditions that triggered the alarm(s) are reset.
For more information about active and historical alarms and warnings,
refer to “Viewing Current Alarms and Warnings” and “Viewing Logged
Alarms or Warnings” in the following pages.
Alarms and warnings that have been reset (no longer active) are stored
in the Alarm Log and Warning Log, accessed from the ALARMS AND
WARNINGS screen. Logged (or historical) alarms and warnings – which
occupy two lines – include the time and date each alarm was set and reset.
The alarm or warning at the top of the list is most recent; the alarm or
warning at the bottom is the oldest.
To Next Page
Loading...
Need help?
General
